2005 Chrysler Town & Country minivan

2005 Chrysler Town & Country minivan (Chrysler Group photo / June 14, 2013)

Question: I've got a 2005 Town & Country minivan. While we were out driving around, I noticed the right front wheel got very hot. So hot I couldn't touch the wheel. It smelled of burning, similar to electrical smoldering. The left front was warm, but not hot. We had only been driving around for about an hour, but there were some hills involved. I had the brake pads and rotors replaced less than a month ago. The van didn't pull to the right or feel like there was a brake issue. I had the mechanics (at least three) examine the brakes, and they could not find any evidence of overheating. Caliper was working freely. So, no parts were replaced after the incident.

What else could cause this? They said they also checked the wheel bearings. This is front-wheel drive. I specifically asked if they would let their mother drive it, and they said yes, it was safe. Should I be concerned? Get another opinion? My brother, a retired mechanic, says there is still something wrong. It just means we haven't found it yet. How would you handle this?

Answer: It sure sounds as if the right front brake caliper piston failed to properly retract or binding of the caliper's sliding pins caused continuing clamping of the brake pads. A faulty wheel bearing can generate considerable heat also, but would have additional identifiable symptoms such as looseness and/or noise. Good job identifying the excessive heat was localized to one wheel, as that rules out a multitude of other possibilities!

Your Town and Country van employs disc brakes on the front axle. Single piston calipers squeeze brake pads against the brake rotors as hydraulic pressure is applied by the master cylinder. When pressure is released, a square cut seal surrounding the caliper piston twists back to its relaxed position, drawing the piston ever so slightly rearward. This action, along with a slight amount of knockback from rotor run-out, allows required brake pad/rotor clearance. The brake caliper floats on pins, allowing the caliper's single-side clamping force to be equalized to both sides of the rotor and relax to an unloaded position.

Your comment about the brakes being recently renewed means the caliper pistons now reside deeply within the caliper bore, in an area previously exposed to possible corrosion and gunk. Brake fluid attracts moisture, and without periodic replacement it's possible to encounter problems such as pitting of the caliper bore and or sticky antilock brake solenoid valves. Contaminated brake fluid is also a possible culprit. Should a petroleum based fluid be accidentally added to the fluid reservoir, swelling rubber seals can lead to a variety of problems. I wonder also if the caliper mounting pins and bores were cleaned and lubricated at the time of brake service. If not, it's possible for them to bind.

There's a reasonable chance this could occur again. After double checking freedom of caliper movement, I'd consider renewing both front calipers, just to play it safe.

---

ABOUT THE WRITER

Brad Bergholdt is an automotive technology instructor at Evergreen Valley College in San Jose, Calif. Readers may send him email at under-the-hood@earthlink.net; he cannot make personal replies.

---

2013 McClatchy-Tribune Information Services

Distributed by MCT Information Services